Optical Unit Removal - Sanyo PLV-WF10 Service Manual

C
C C
C
B
B
B
B
A
A
A
E
E
E
E
G
G
F
F
D
D
D
D
D
D
-11-
5. Assembly Motor & audio, assembly Power, assem-
bly PFC, assembly Sub power, assembly PFC Fan-
net and Fan(FN902 and FN913) Removal.
The following caution is the important mat-
Caution:
ter for maintaining the safety of a product.
Don't mistake the attachment direction of the cooling fan in the
case of a re-assembly. (Refer to the arrow in a figure.) If the
attachment direction is mistaken, it will become the cause which
the inside of the projector is unusually overheated and a fire or
parts damage.
01. Remove 3 screws A and remove the assembly motor &
audio.
02. Remove 4 screws B and remove the power holder.
03. Remove 4 screws C and remove the power holder top.
04. Remove 6 screws D and remove the assembly sub power.
05. See caution before the Fan (FN902) removal.
06. Remove 4 screws E and remove the Fan (FN902).
07. Remove 2 screws F and remove the Fan (FN913).
08. Remove 2 screws G and remove the assembly PFC Fan-
net.
09. Pull the assembly power upward and remove.
10. Pull the assembly PFC upward and remove.
6.

Optical unit removal.

Remove 12 screws and then pull the
optical unit upward and remove.