Sanyo PLV-WF10 Service Manual page 51

Screw A Screw A
Lever B Lever B
SLOT-B
SCREW-A
SLOT-C
R-Filter adjustment
R - R -
F i F i
l t e l t e
r u r u
n i t n i t
Relay-lens adjustment
SCREWS-A
SCREW-A
-51-
Before Adjustment :
1. Remove the connector K8E and connector K8V,
and remove the flexible cables on LCD panels
from the assembly Main. And turn on the projec-
tor.
2. If the shade appears on the left and right of the
screen, adjust the R-Filter with the following pro-
cedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen screw-A.
3. Move and adjust the lever B in the direction of
an arrow so that the shade may disappear or
reduce.
4. Tighten the screw-A to fix the R-Filter.
Before Adjustment :
1. Remove the connector K8E and connector K8V, and
remove the flexible cables on LCD panels from the
assembly Main. And turn on the projector.
2. If the shade appears on the screen, adjust the Relay-lens
with the following procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen four screws-A.
3. If it appears on the top or bottom.--->
If it appears on the left or right. ----->Use slot-C.
Insert slot screwdriver into each slot, turn and adjust it
so that the shade on the screen may disappear or
reduce.
4. Tighten the four screws-A to fix the Relay-lens.
Use slot-B.