Sanyo PLV-WF10 Service Manual page 107

LENS REPLACEMENT AND INSTALLATION PROCEDURE
NOTE : The installation procedure and needed parts
for lens installation depend on the type of the
Projection Lens. Check the Model No. of the
Projection Lens and be sure to install or replace the
lens following procedure below.
1
Remove Lower Lens Cover. Remove 2 Screws A.
Push part B and pull Lower Lens Cover down.
(See Fig. 1.)
2
Remove 4 Screws C. Pull Upper Lens Cover
toward front and remove. (See Fig. 2.)
3
Remove 2 Screws D and Cover Plate on the back
of Upper Lens Cover. (See Fig. 3.)
A
UPPER LENS
COVER
COVER PLATE
- 107 -
B
LOWER LENS
COVER
C
C
UPPER LENS
COVER
D
Fig-1
Fig-2
Fig-3