Sanyo PLV-WF10 Service Manual page 109

6
This projector has 3 Light-Block Sheets. Use Light-Block Sheet corresponding with lens. (Refer to the list
below.)
Set Light-Block Sheet through the lens.
Make sure the shape of the Light-Block Sheets are correct and be sure to set them as shown in the Fig. 8.
NOTE:
Be sure to set each Light-Block Sheet as shown in Fig-8.
Make sure the mark (TOP and BACK) on Light-Block Sheets are correct and set them properly.
Light-Block Sheets For each lens.
Lens Model No.
LNS-S02, LNS-S02Z, LNS-S03
LNS-M01, LNS-T02, LNS-W02
LNS-M01Z, LNS-W02Z, LNS-S01
LNS-W03
LNS-W01, LNS-T01, LNS-W01Z
LNS-T01Z
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
Type No. (Part No.)
TYPE FD1 (610 290 9258)
TYPE FE1 (610 293 8937)
TYPE FF1 (610 299 6302)
Not include Light-Block Sheet
Mounting Base and screws.
For Models
LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
Mount the Light-Block Sheet
with 2 screws.
- 109 -
Fig-8