Sanyo PLV-WF10 Service Manual page 46

LCD Panel convergence adjustment.
Preparation before
adjustment.
Install a "Convergence adjuster" with the following
procedure before a convergence adjustment.
1. Loosen 2 screws B on a convergence adjuster. (See figure-1)
2. Put a convergence adjuster on a prism unit, insert 2 screws A
and tighten it a bit. (See figure-1)
(2 screws A are contained in this adjuster package)
3. Loosen 2 screws D. (Figures 3 and 4) And move the LCD
panel unit to the position which you can insert a convergence
SCREW-A
SCREW-B
SCREW-B
SCREW-A
convergence
GUIDE
C
Fig.-2
C
adjuster to the LCD panel unit easily. (See figures 2 and 4.)
4. Slide a convergence adjuster in the direction of the arrow-
and insert a convergence adjuster to the LCD panel unit. (See
figures 2 and 4.)
5. Tighten 2 screws A and 2 screws B. Preparation of conver-
gence adjustment has been completed.
To remove the adjuster, take reversed step in the above.
Convergence Adjuster :
The convergence adjustment tool can be ordered.
See page 44.
Fig.-1
INSERT
ZOOM IN
-46-
Convergence Adjuster
(Convergence adjustment tool)
F
E
Fig.-3
Screw-D
Screw-D
Fig.-4
C
G
Screw-D