Sanyo PLV-WF10 Service Manual page 48

Before Adjustment :
1. Remove the flexible cables on LCD panels
from the assembly Main. And turn on the
projector.
2. If the shade appears on the left or right of the
screen, adjust the integrator lens out with the
following procedure.
Adjustment :
1. Loosen three screws-B.
2. Insert a slot screwdriver into slot-A, turn and
adjust it so that the shade may disappear or
reduce.
3. Tighten the three screws B to fix the integra-
tor lens out.
Fine adjustment-1
(Refer to Fine adjustment-1 on page-49)
Integrator-lens-out adjustment
Change the lamp mode to "Lamp-1".
(Refer to operation method-1 on page-49)
Check the condition of Unevenness color on
the screen.
Unevenness color : N.G.
Integrator lens out
Unevenness color : Good
Change the lamp mode to "Lamp 1 and 2".
(Full lamp mode)
(Refer to operation method-1 on page-49)
END
START
Integrator-lens-out unit
SCREW-B
SCREW-B
Unevenness color : Good
Change the lamp mode to "Lamp-2".
(Refer to operation method-1 on page-49)
Check the condition of Unevenness color on
the screen.
Unevenness color : N.G.
Fine adjustment-1
(Refer to Fine adjustment-1 on page-49)
Change the lamp mode to "Lamp-1".
(Refer to operation method-1 on page-49)
-48-
BOTTOM
SIDE
SLOT-A SCREW-B
Integrator lens out