Lighting The Side Burner - Vermont Castings Signature VCS301 Series User Manual

Operation
rotisserie setup
WarnInG
•
Never attempt to use the rotisserie burner for any purpose other than rotisserie cooking.
•
Never use the main burners while using the Rotisserie burner, as that could result in igniting the drip-
pings, or overheating your Grill.
•
Never use the Rotisserie Motor in the rain, and never use it if it has become wet.
•
Always use a grounded three-prong outlet and a three-prong extension cord to energize the Rotisserie
Motor. Never alter or remove the grounding prong on the Rotisserie Power Cord, as an electric shock
hazard would then result.
•
Keep any electrical supply cord and the fuel supply hose away from any heated surface.
•
Electrical Grounding Instructions: This outdoor cooking gas appliance is equipped with a three-prong
(grounding) plug for your protection against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
lighting the side Burner (if applicable)
WarnInG
NOTE: Side burner assembly instructions are included in the box with the Side Burner Kit.
Never stand directly over the Grill when lighting the side burner, to avoid exposure to possible flare-ups.
1. Ensure the main Propane Tank Valve or the main Natural Gas supply valve are in the on position. Turn
the side burner control knob to HIGH. (Fig. 13)
2. Push and hold the Igniter Button, you will hear a series of clicks as the igniter module generates an
ignition spark to the burners. The burner should light within five seconds. (Refer to Page 13)
3. Check the flame pattern. Soft blue flames are normal, hard blue flames or wavy yellow flames
are not. Adjust the flame pattern with the air shutter below the control knob. (Fig. 18, as nec-
essary. If yellow flames persist, refer to the
Troubleshooting Guide on Page 29.
sHUTTInG THe BUrner �FF
Turn the control knob counterclockwise to the HIGH posi-
tion, then depress it and turn it to OFF.
NOTICE
NEVER apply force to the control knob without depressing
it, as that can damage the valve.
18
(continued)
Figure 13
OFF
HI
B210
20302820