Lighting The Side Burner; Lighting The Sear Burner - Vermont Castings VCS Series User Manual

rotisserie setup
(continued)
WarnInG
•
Never use the main burners while using the Rotisserie burner, as that could result in igniting the drip-
pings, or overheating your Grill.
•
Never use the Rotisserie Motor in the rain, and never use it if it has become wet.
•
Always use a grounded three-prong outlet and a three-prong extension cord to energize the Rotisserie
Motor. Never alter or remove the grounding prong on the Rotisserie Power Cord, as an electric shock
hazard would then result.
•
Keep any electrical supply cord and the fuel supply hose away from any heated surface.
•
Electrical Grounding Instructions: This outdoor cooking gas appliance is equipped with a three-prong
(grounding) plug for your protection against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
lighting the side/sear Burner (if applicable)
WarnInG
nOTe: Burner assembly instructions are included in the box with the
Burner Kit.
Never stand directly over the Grill when lighting the side/sear burner, to
avoid exposure to possible flare-ups.
CaUTIOn: The side/sear Burner should only be operated with
the protective lid/cover in the Up/Open position. Do not attempt
to light the burner with the cover closed.
side Burner lighting Instructions
1. Ensure the main Propane Tank Valve or the main Natural Gas
supply valve are in the on position. Turn the side burner control
knob to HIGH. (Fig. 13a)
. Push and hold the igniter button, you will hear a series of clicks as the igniter
module generates an ignition spark to the burners. The burner should light
within five (5) seconds. (Refer to Page 13)
3. Check the flame pattern. Soft blue flames are normal; hard
blue flames or wavy yellow flames are not. Adjust the flame
pattern with the air shutter below the control knob. (Fig.
18, as necessary) If the yellow flames persist, refer to the
Troubleshooting Guide on Page 30.
sear Burner lighting Instructions
1. Ensure the main propane tank valve or main natural gas
supply valve is in the On position.
. Push in and turn the sear burner control knob counterclock-
wise to HIGH. Hold the knob pushed-in. You will hear a
series of clicks as the igniter module generates repeated
ignition sparks to the burner. The burner should light within
five (5) seconds. After burner lights, release control knob.
30005801
Operation
OFF
HI
Figure 13a - Side Burner
Figure 13b -
Sear Burner
B415
B10
19