•
Shut stove off if the firepot overfills with pellets or the flame becomes dark and sooty. This indicates
poor fuel combustion and the cause should be investigated and remedied. (See Trouble Shooting tips for
possible causes)
•
It's critical for proper operation that you maintain unobstructed airflow through the intake vents of the
stove. The viewing door and ash pan must be closed and latched during operation. Never abuse the
door by slamming it shut.
•
The pellet appliance exhaust system works with negative combustion chamber pressure and positive
chimney pressure. The exhaust system must be completely airtight and properly installed. All exhaust
vent joints must be tightly sealed with gasket and or HI‐TEMP
sheet metal screws per joint.
•
For required periodic maintenance and cleaning refer to Section #6 "Maintenance & Required Cleaning"
of this manual. Failure to maintain your stove may lead to poor operation and exhaust fume leakage
into your home. Only use replacement components that are authorized by Hearthland Products, LLC.
•
Always disconnect power from your stove before performing any maintenance. Power Cord must be
unplugged. Pushing "OFF" Touch Pad does not disconnect all power to the stove.
•
To avoid accidental fire, DO NOT place any flammable item on or near the stove.
•
To prevent burns, maintenance or cleaning, should only be performed on a cool stove.
•
Hearthland Products grants no warranty, implied or stated, for the maintenance or installation
of your stove, and assumes no responsibility whatsoever of any consequential damage to
stove or its surroundings.
S
L
:
AFETY
ISTING
In accordance with the procedures and specifications listed in ASTM E1509‐04, ULC/ORD‐C1482‐M1990, and ULC S627‐
00 for solid fuel room stove, Hearthland Products, pellet stoves have been independently tested and listed by Omni Test
Laboratories, Inc. Portland, Oregon (an accredited testing laboratory). It is tested and listed for residential installation
according to current national and local building
codes as:
•
FREESTANDING ROOM HEATER
•
ROOM HEATER, PELLET FUEL‐BURNING TYPE,
ALSO FOR USE IN MOBILE HOMES
The Safety Listing Label is located on the rear
panel . Read the label carefully. It contains infor‐
mation about the installation and operation of
your stove. The stove's serial number is located
on the safety label. Your serial number is pre‐
ceded by a "OMNI‐" (example OMNI‐00000). (see
diagram).
VS0952_E
IMPORTANT
12/30/2009
RTV silicone sealant, and at least 3
(550°F)
5