Table of Contents
Advertisement
O
O
PERATING
FILLING THE HOPPER WITH FUEL:
Open the hopper lid using the finger pull recess. Fully open the
lid toward the back of the stove. Ensure the hopper is free of
unwanted debris, MANUALS, or other foreign objects before
adding wood pellets.
Fill the hopper with wood pellets only. The hopper has a 70 lb
capacity. When filling, be careful not to spill any fuel on the
top of the stove and floor as they can also pose a slipping haz‐
ard. Before closing the lid, verify there are no pellets on the
hopper switch or stop ledge, as they may prevent the lid from
closing properly. To close, gently lower the lid.
Note: To prevent injury, your stove is equipped with a switch
that stops the auger when the hopper lid is open. If the lid is
opened during operation longer than 60 seconds, the stove will
enter shutdown mode. If this happens unintentionally, close
the lid and press start on the touchpad.
INTELLIGENT TEMPERATURE CONTROL (ITC) GENERAL OVERVIEW
The Intelligent Temperature Control (ITC)
digital control is designed to give you flexibility
on how you use your stove.
The ITC can be operated in one of
three modes:
•
Manual Mode (Factory default)
•
Thermostat ON/OFF Mode
•
Thermostat Modulated Mode (High/
Low)
The touchpad has three functional but‐
tons:
•
"START" (HEAT LEVEL) begins your stove's ignition process and adjusts desired heat setting.
•
"FAN SPEED" adjusts convection blowers (room heat) to desired setting.
•
"OFF" begins shut down mode of your stove.
Four indicator lights informing you of functional status:
•
"IGNITER" LED indicates when the automatic Ignition System is under power.
•
"FUEL FEED" LED solid indicates when the auger is turning and pellets are being fed to the burn grate. Blinking
indicates vacuum fault, hopper lid open or stove over temp.
•
"HEAT LEVEL" LED indicates current heat level setting. Blinking slow indicates cold start; blinking fast indicates
hot start.
•
"FAN SPEED" LED indicates the setting of the convection blowers (room heat). Blinking indicates shutdown
mode.
Two Trims allow for setting dependant adjustments at installation:
•
F1 is the Combustion Fan Trim. This allows for fine tuning of the combustion fan aiding in adjustment for eleva‐
tion & venting.
•
T1 is the ITC temperature trim. This allows for heat setting temperature to be raised or lowered to meet your
heating needs.
VS0952_E
I
I
NSTRUCTIONS
PERATING
NSTRUCTIONS
(C
(C
ONTINUED
ONTINUED
12/30/2009
)
)
Hopper Lid
Hopper Switch
Stop Ledge
24
Advertisement
Table of Contents
