Table of Contents
Advertisement
•
COMPLETE THE CHECK LIST (Section #2.1 "Pre‐Installation Checklist" ) PRIOR TO LIGHTING YOUR FIRST
FIRE.
•
When using your appliance, it is critical that the following concepts be understood and performed as re‐
quired!
•
Use only Hearthland Products supplied burn grate.
•
Each stove installation is unique, therefore it is not possible for the manufacturer to preset all stove set‐
SETTING THE AIR INTAKE DAMPER
•
The damper helps to control the amount of airflow supplied for
combustion.
•
Damper pushed in reduces airflow.
•
Damper pulled out increases airflow.
•
For ignition, push the air damper in completely, then pull outward approximately
1/4".
•
This setting will be fine tuned after ignition (See Section
#4.11 "Adjusting Air Intake Damper")
DOOR OPERATION:
•
Open the stove door by pulling the handle UP toward the TOP of the stove,
until the door naturally opens. Swing door open to the left.
•
Close the stove door by keeping the handle in the open position. Push the
door firmly against the stove.
•
Push the handle downward to the locked position.
•
NOTE: If left open during operation for more than 60 seconds, the stove will
enter shutdown mode.
BURN GRATE REMOVAL & INSTALLATION:
WARNING: Make sure the stove has totally cooled down before
touching the burn grate.
•
The Fuel Burn Grate comes in two pieces; the burn grate (A)
& the burn pot top plate (B).
•
To remove the Burn Grate grab the Burn Grate and Burn Pot
Top Plate and rotate the two parts out as a unit as shown in
the photo on the right.
•
To re‐install ensure that the Burn Grate (A) is seated tightly in
the Top Plate (B). Rotate the rear flange of the Burn Grate
under the Brick Panel then seat the Top Plate over the 3 Lo‐
cating Tabs. Ensure the Burn Grate and Top Plate are properly
seated and level.
VS0952_E
O
I
PERATING
NSTRUCTIONS
IMPORTANT
12/30/2009
Damper
Rod
Damper
Fresh Air Inlet
Locating
Tab
B
A
Rear Flange
Locating
Tabs
23
Advertisement
Table of Contents
