Hearthland Itasca Installation And Operation Manual page 28

O
SETTING MODE OF OPERATION
The ITC can be operated in one of three modes:
NOTE: To operate in either of the two thermostat modes, an optional thermostat kit must be purchased and installed.
Thermostats compatible with your Hearthland stove are available from your local dealer.
To change mode of operation:
1. Press and hold the OFF button,.
2. While you are holding the OFF button the following cycle will occur:
3. All four feed rate lights light solid.
4. 2 of the feed rate lights will flash indicating current operation mode.
5. All four feed rate lights light solid.
6.
2 of the feed rate lights will flash indicating current operation mode.
7.
This cycle will continue as long as you continue to hold the OFF button. To select a mode,
simply release the OFF button when the desired mode is displayed.
1st & 4th Heat Level
MANUAL MODE
(NON‐THERMOSTAT)
VS0952_E
I
PERATING NSTRUCTIONS
⇒
Manual Mode (Factory default)
⇒
Thermostat ON/OFF Mode
⇒
Thermostat Modulated Mode (High/Low)
All 4 Lights
All 4 Lights
(C
(C
ONTINUED
ONTINUED
1st & 2nd Heat Level
THERMOSTAT
ON/OFF MODE
3rd & 4th Heat Level
THERMOSTAT MODULATED
MODE (HIGH/LOW)
12/30/2009
)
)
All 4 Lights
28