Step.3:.Connect.the.cables - Proxim AP-4000MR-LR Quick Install Manual

step 3: Connect the Cables
1. If.you.have.not.already.done.so,.connect.the.normal.RJ45.connector.on.an.
outdoor-rated.CAT5.cable.to.the."Data.and.Power.Out".port.on.the.power.
injector..
Note:
On.R1.versions,.connect.the.cable.to.the.port.labeled."J1.Antenna".on.the.
power.injector.(not.pictured)..This.port.has.48.VDC.power.on.the.RJ45.
2. Attach.the.other.end.of.the.CAT5.cable.with.RJ45.connector.to.the.Power.
and Ethernet port on the back of the unit (see the following figure). Note
that the first attachment of this cable is meant to verify operation and
configure the unit; the final attachment (with proper torque values) and
weatherproofing are to be done after the unit has been installed in the
location.at.which.it.will.operate.(See Step 7: Complete Installation).
Caution!
Do.not.over-tighten.the.connector.nuts;.do.not.use.a.wrench.to.
tighten.the.connectors!..
All rights reserved Page 13