Boot Settings Screen; Integrated Devices Screen - Dell PowerEdge T110 II Owner's Manual

Option
Port D
(Off default)
Port E
(Auto default)
eSATA port
(Auto default)

Boot Settings Screen

Option
Boot Mode
(BIOS default)
Boot Sequence Retry
(Disabled default)

Integrated Devices Screen

Option
User Accessible
USB Ports
(All Ports On default)
Internal USB Port
(On default)
Embedded NIC1 and
NIC2
(Enabled default)
Description
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
Auto enables BIOS support for the device attached to the
eSATA port. Off disables BIOS support for the device.
Description
CAUTION:
the system from booting if the operating system was
not installed in the same boot mode.
If the operating system supports Unified Extensible
Firmware Interface, you can set this option to UEFI.
Setting this field to BIOS allows compatibility with non-
UEFI operating systems.
NOTE:
Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
If this field is enabled and the system has failed to boot,
the system will reattempt to boot after 30 seconds.
Description
Enables or disables the user-accessible USB ports.
Options are All Ports On, Only Back Ports On, and All
Ports Off.
Enables or disables the internal USB port.
Enables or disables the operating system interface of the
NIC1 and NIC2 controllers. (The NICs may also be
accessed through the system's management controller).
Using the System Setup Program and UEFI Boot Manager
Switching the boot mode could prevent
41