Dell PowerEdge T110 II Owner's Manual page 23

Message
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings.
Manufacturing
mode detected.
Maximum rank
count exceeded.
The following
DIMM has been
disabled: x
Memory address
line failure at
address, read
value expecting
value.
Memory double
word logic
failure at
address, read
value expecting
value.
Memory
Initialization
Warning: Memory
size may be
reduced.
Causes
The USB ports are disabled
in the system BIOS.
System is in manufacturing
mode.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Faulty or improperly
installed memory modules.
Faulty or improperly
installed memory modules.
Invalid memory
configuration. The system
will run but with less
memory than is physically
available.
Corrective Actions
Power down and restart the
system from the power button,
and then enter the System
Setup program to enable the
USB port(s). See "Entering the
System Setup Program" on
page 36.
Reboot to take the system out
of manufacturing mode.
Ensure that the memory
modules are installed in a valid
configuration. See "General
Memory Module Installation
Guidelines" on page 86.
See "Troubleshooting System
Memory" on page 119.
See "Troubleshooting System
Memory" on page 119.
Ensure that the memory
modules are installed in a valid
configuration. See "General
Memory Module Installation
Guidelines" on page 86.
About Your System
23