Dell PowerEdge T110 II Owner's Manual page 20

Message
Alert! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Alert!
Continuing
system boot
accepts the risk
that system may
power down
without warning.
Alert! System
fatal error
during previous
boot.
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
BIOS Update
Attempt Failed!
20
About Your System
Causes
The system configuration
of processor, memory
modules, and expansion
cards may not be supported
by the power supply.
An error caused the system
to reboot.
System is in manufacturing
mode.
Remote BIOS update
attempt failed.
Corrective Actions
If any system components
were just upgraded, return the
system to the previous
configuration. If the system
boots without this warning,
then the replaced
component(s) are not
supported with this power
supply. See "Power Supply" on
page 99.
Check other system messages
for additional information for
possible causes.
Reboot to take the system out
of manufacturing mode.
Retry the BIOS update. If
problem persists, see "Getting
Help" on page 135.