Integrated Peripherals Page - ECS P49G Series User Manual

Integrated Peripherals Page

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard IDE Controller
OnBoard SATA Controller
Onboard AUDIO Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
USB Functions
Legacy USB Support
: Move Enter: Select +/-/: Value
F1: General Help
Onboard IDE Controller
Use this item to enable or disable the onboard IDE interface.
Onboard SATA Controller
This item allows you to enable or disable the onboard SATA controller.
Onboard AUDIO Function
Use this item to enable or disable the onboard audio device.
Onboard LAN Function
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address
Use this item to enable or disable the onboard COM1 serial port, and to assign a
port address.
Parallel Port Address
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
ECP Mode DMA Channel
Use this item to assign the DMA Channel under ECP Mode function.
Chapter 3: BIOS Setup Utility
Integrated Peripherals
Enabled
Enhanced
Enabled
DISABLED: disables the
Enabled
integrated IDE
Disabled
Controller.
3F8/IRQ4
ENABLED: enables both
378
Controllers.
ECP
DMA3
IRQ7
Enabled
Enabled
F10: Save Esc: Exit
F9: Load Default Settings
27
Help Item