Conair GasTrac User Manual page 8

ATTENTION:
!
R
EAD THIS SO NO
ONE GETS HURT
1-4
I
NTRODUCTION
WARNING
Temperatures inside the GasTrac can
reach more than 800˚ F. Always shut
down the GasTrac and host dryer and
wait for them to cool before servicing. Do
not remove the safety guard covering the
GasTrac burner and heat exchanger.
WARNING:
main power before servicing.
The GasTrac is connected to high volt-
age. Always disconnect and lock out the
main power source to the GasTrac before
servicing. Also disconnect and lock out
main power to the host dryer before ser-
vicing the GasTrac. Failure to disconnect
and lock out this voltage source could
result in severe personal injury.
WARNING:
! and purge heat exchanger and gas
lines before servicing.
If the fuel train, burner, ultraviolet sensor,
sight glass or ignition are to be serviced,
it is important that the GasTrac heat
exchanger and gas lines are purged of
natural gas. Failure to eliminate this
potential source of a gas leak could result
in severe damage, personal injury or loss
of life.
WARNING:
GasTrac with safety features disabled
!
or removed.
The GasTrac has been equipped with
numerous guards, controls and devices
to ensure safe operation. Never remove
or disable these devices to sustain pro-
duction. Operating without these devices
could lead to hazardous conditions that
can damage the facility or cause severe
injury or loss of life.
GasTrac Process Air Heater
: Hot surfaces.
Disconnect and lock out
Shut off main gas supply
Do not operate the
UGD014/0497