Before Beginning; A Few Words Of Caution - Conair GasTrac User Manual

B
EFORE
B
EGINNING
A F W
EW ORDS
C
OF AUTION
6-2
T
ROUBLESHOOTING
You can avoid most problems by following the recommended
installation and maintenance procedures outlined in this Users
Guide. If you do have a problem, this section will help you
determine what caused it and tell you how to fix it.
Before you begin troubleshooting
Find the wiring and assembly diagram
received with your GasTrac. These diagrams will note any
custom features such as special wiring or alarm capabili-
ties not covered in the User Guide.
Find the instruction manuals and diagrams that
were shipped with the GasTrac and your host dryer.
Find any installation diagrams or notes which may
have been generated at the time the GasTrac was
installed.
WARNING
and repaired by qualified technicians who are
equipped with the correct tools and are experi-
enced in the maintenance and repair of industrial
gas appliances.
WARNING
Temperatures inside the GasTrac can reach more
than 800˚ F. Always shut down the GasTrac and
host dryer and wait for them to cool before ser-
vicing.
WARNING:
power before servicing.
The GasTrac is connected to high voltage.
Always disconnect and lock out the main power
source to the GasTrac before servicing. Also dis-
connect and lock out the main power to the host
dryer before servicing the GasTrac. Failure to dis-
connect and lock out this voltage source could
result in severe personal injury.
WARNING:
purge heat exchanger and gas lines before
servicing.
Failure to eliminate this potential source of a gas
leak could result in severe damage, personal
injury or loss of life.
GasTrac Process Air Heater
:
: The GasTrac should be maintained
: Hot surfaces.
Disconnect and lock out main
Shut off main gas supply and
you
UGD014/0497