Conair GasTrac User Manual page 33

The GasTrac control is the primary operator interface. This
control may have been mounted in a remote location.
Power On/Off
This switch sends power to
the burner controller, the
GasTrac control and the
process and safeguard relay
devices The switch illumi-
nates when power is ON.
235.0
OP1
OP2
250.0
SP2
REM
RUN
HOLD
MAN
Run Button
Push to start
the GasTrac.
Temperature Controller
234.0
OP1
OP2
250.0
SP2
REM
RUN
HOLD
MAN
Scroll button
Press to scroll through parameter lists to select a parameter to modify.
Page button
Press to select parameter lists during setup and configuration of the controller.
MAN: Indicates the controller is being manually operated by the operator.
SP2: Indicates the controller will control to setpoint #2 when in automatic mode.
OP1: Indicates the variable frequency controller output is active.
UGD014/0497
Alarm Light
An illuminated light Indicates the
GasTrac has shutdown on an
alarm condition. The Trouble-
shooting section will help you
identify and correct the problem.
2216
Run Light
An illuminated
light indicates
the GasTrac is
operating.
2216
Actual
temperature
Setpoint
temperature
Up button
Press to increase a value or scroll up through a list.
Down button
Press to decrease a value or scroll down through a list.
GasTrac Process Air Heater
T
C
Stop Button Emergency Stop Button
Push to stop Push to shutdown the
the GasTrac. GasTrac during an emer-
gency. Pull to restore
power before restarting.
See the Eurotherm Temperature
Controller manual in the instruction
packet for a full description of alarm
messages, programming modes and
parameters.
G T
HE AS RAC
ONTROL
O
PERATION
4-3