Unpacking The Boxes - Conair GasTrac User Manual

U
NPACKING
B
THE OXES
Optional Remote
Control Bracket
If you ordered the optional
bracket for mounting the
GasTrac control in a
remote location, see the
Appendix for installation
instructions.
3-2
I
NSTALLATION
The GasTrac Process Air Heater arrives assembled. The RTD
temperature probe is packaged inside the electrical enclosure.
Depending on the model and options ordered, you also
should receive boxes containing V clamps and piping to
attach the GasTrac exhaust to a customer-installed flue.
Exhaust
flue Tee
1 "V" clamp
Temperature
probe (RTD)
CGT horizontal model
1
Carefully remove the GasTrac and components
from their shipping containers.
2
Remove all packing material
and plastic. Be sure to examine packing material before
discarding. What looks like filler may contain parts, hard-
ware or instructional materials.
3
Carefully inspect all components.
have the correct model and all necessary hardware. Check
for any damage that may have occurred during shipping. If
you do find freight damage, you should immediately file a
damage claim against the delivering carrier.
4
Take a moment to record serial numbers
cal power and gas specifications in the blanks provided on
the back of the User Guide title page. This information
will be helpful if you ever need service or parts.
5
You are now ready to begin installation.
Follow all preparation steps beginning on the next page.
GasTrac Process Air Heater
Exhaust
flue Tee
Exhaust
flue elbow
2 "V"
clamps
CGT upright model
, protective paper, tape
Make sure you
Temperature
probe (RTD)
, electri-
UGD014/0497