To Start Drying - Conair GasTrac User Manual

T S
O TART
D
RYING
4-4
O
PERATION
The temperature controller is factory configured to start and
operate in automatic mode.
1
Start the host dryer.
2
Turn the main power disconnect to
the or position.
I ON
The variable speed controller turns on.
2216
235.0
OP1
OP2
3
250.0
SP2
REM
RUN
MAN HOLD
4
3
Press the Power switch to ON.
The Power
ON/OFF
The temperature controller begins a 3-second self-test.
The display will flash between
temperature.
The Burner Controller begins a 10-second initiation,
which ends when the display indicates
4
Set the drying temperature.
Press the the up or down arrow on the
temperature controller until the recom-
mended drying temperature appears in
the lower display.
NOTE: The temperature units were set at the
factory in ˚F or ˚C, as specified in the order.
To see which temperature unit was set:
Press the
To change the temperature unit:
See the Eurotherm Temperature Controller manual
5
Press the RUN button.
The green RUN light will illuminate after the Burner
Controller finishes initializing.
The combustion blower will start and run for 90 sec-
onds to purge any residual gas from the burner.
After the purge, the burner will ignite on low fire (low
blower speed) for about 15 seconds. The burner will
alternate between high and low fire as required to main-
tain the setpoint temperature.
GasTrac Process Air Heater
5
switch illuminates.
STANDBY
button once. F or C will be displayed.
I
and the setpoint
.
STANDBY
2216
234.0
OP1
OP2
250.0
SP2
REM
RUN
MAN HOLD
UGD014/0497