Getting On And Off - 2GOability Quest User Manual

Battery gauge ripples
The joystick has been displaced out of the neutral position while the control system is
switched on. Release the joystick to clear the fault. Note that this is not a fault. If the
condition persists after removing your hand, the joystick may be damaged. Contact
your 2GOability dealer.
Battery gauge flashes rapidly
The control system safety circuits have operated and the control system has been
prevented from moving the wheelchair. This indicates a system trip, i.e. the VR2 has
detected a problem somewhere in the wheelchair's electrical system.
Please follow this procedure
Place the joystick in the center position and turn the control system off and on

again to clear the fault. If the fault does not clear, go to the next step;
Switch off the control system;

Disconnect and reconnect all connectors on the wheelchair and the control

system to make sure they are mated securely;
Check the condition of the battery;

If you can't find the problem, see chapter 8;

Switch on the control system again and try to drive the wheelchair. If the safety

circuits operate again, switch off and do not try to use the wheelchair. Contact
your 2GOability dealer.
 Tip
For your safety, the controller automatically sets the reverse speed, acceleration
and deceleration in proportion to the speed control setting.

4.2 Getting on and off

 Warning:
When getting on or off your power chair, keep your weight toward the middle of

the deck. Putting most or all of your weight on the edge of the deck may cause
an unstable condition!
Never transfer on or off of the power chair using the seat backrest for support

during transfer. The seat back may fold down and may cause you to lose your
balance and could result in personal injury.
10
Quest