Installing The Hydraulic Unit - Yamaha 2003 FJR1300 Service Manual

ANTI-LOCK BRAKE SYSTEM (FJR1300A)

• Installing the hydraulic unit

Proceed in the reverse order of disassembly.
Pay attention to the following items.
1. Install:
• hydraulic unit bracket 1 1
NOTE:
Tighten the nuts in the proper sequence.
2. Install:
• hydraulic unit
NOTE:
_
Do not allow any foreign materials to enter the
hydraulic unit or the brake hoses when install-
ing the hydraulic unit.
CAUTION:
_
Do not remove the rubber plugs or bolts
(M10 × 1.25) installed in the union bolt
holes before installing the hydraulic unit.
3. Remove:
• rubber plugs or bolts (M10 × 1.25)
4. Install:
• copper washer
• brake hose 1 (to the rear brake caliper)
• brake hose 2 (from the rear brake master
cylinder)
• brake hose 3 (to the front brake caliper)
• brake hose 4 (from the front brake master
cylinder)
• union bolt
WARNING
_
The brake hoses to the front and rear brake
calipers can be distinguished by the rubber
at the end of each hose. Be sure to connect
each brake hose to the correct union bolt
hole.
CAUTION:
To route the front and rear brake hoses,
refer to "CABLE ROUTING".
– 118 –
CHAS
16 Nm (1.6 m · kg)
New
30 Nm (3.0 m · kg)