Final Check; Checking The Brake Fluid Level Of The Brake Master Cylinder Reservoirs; Checking The Wheel Sensors For Proper Installation - Yamaha 2003 FJR1300 Service Manual

ANTI-LOCK BRAKE SYSTEM (FJR1300A)
l. Tighten the bleed screw to the specified
torque.
Bleed screw
6 Nm (0.6 m · kg)
m. Fill the brake fluid reservoir to the proper
level with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" in chapter 3.
(Manual No.: 5JW1-AE1)
WARNING
After bleeding the ABS, check the brake
operation.
L LLL L LLL L
• [D-6] Final check
Checking procedures
1. Check the brake fluid level in the brake mas-
ter cylinder reservoirs.
2. Check the wheel sensors for proper installa-
tion.
3. Perform hydraulic unit operation test 1 or 2.
4. Delete the malfunction codes.
5. Perform a trial run.
• [D-6-1] Checking the brake fluid level of
the brake master cylinder reservoirs
1. Check:
• brake fluid level
Refer to "CHECKING THE BRAKE FLUID
LEVEL" in chapter 3.
(Manual No.: 5JW1-AE1)
• [D-6-2] Checking the wheel sensors for
proper installation
1. Check if the front wheel sensor housing and
the rear wheel sensor housing are installed
correctly. (Refer to "[D-3] Maintenance of
the front wheel sensor and sensor rotor"
and "[D-4] Maintenance of the rear wheel
sensor and sensor rotor".)
– 123 –
CHAS
L LLL L L LLL L L LLL L L LLL L LLL