Switch Fabric Module Leds - HP ProCurve 8100fl Series Installation And Getting Started Manual

10/100 Base-T Data Terminal Equipment (DTE) Port. Use the
RJ-45 port to manage a ProCurve 8100fl Switch from a management
workstation through an inband Telnet session. The RJ-45 port is configured
as a media data interface (MDI). For out-of-band console access, you can also
connect directly to the RJ-45 serial port on top of the chassis (see
PCMCIA Flash Card. The PCMCIA card slot holds a PC flash memory card
(reserved for future software releases).

Switch Fabric Module LEDs

Switch fabric modules have two LEDs: an Active LED (on top) and a Status
LED (on bottom). The LED states are described in the following table.
Table 1-2.
Switch Fabric Module LEDs
Active and
Status LEDs
Switch Fabric Module (J8729A/J8730A)
LED Color State
Active Green Flashing
Green Solid
n/a Off
Status n/a Off
Green Flashing
Green Solid
Yellow/ Flashing
Orange
Introducing the ProCurve Series 8100fl Switch
LED
Meaning
Negotiating active/backup switch fabric
module(s) during boot sequence.
Module is active - normal.
Module is in back up mode.
No power to the module.
Module is powering up and downloading
operating software.
Module is in service - normal.
Self-test failure.
Front of the Switch
page 2-27).
1-7