N o t e
4.
5.
6.
7.
N o t e
The ProCurve Switch 8100fl supports up to 10 vty connections for a maximum
of ten incoming remote connections, plus one console connection.
The management0 interface is created automatically by the system and is
reserved for the management port on the management module.
From Interface Management mode, enter the following command:
Switch 8100fl(config-interface-management)#ip address
<ipaddr>
where
is the IPv4 unicast address and subnet mask you assign
ipaddr
<
>
to the switch. You can specify the subnet mask in terms of mask bits.
For example:
ip address 10.10.1.45 255.255.248.0
You can also specify the subnet mask in terms of mask length.
For example:
ip address 10.10.1.45/21
Enable the management port, by entering the following command:
Switch 8100fl(config-interface-management)#no shutdown
Here is an example, showing all of the preceding steps:
Switch 8100fl>enable
Switch 8100fl#configure
Switch 8100fl(config)#interface management0
Switch 8100fl(config-interface-management)#ip address
10.10.1.45 255.255.248.0
Switch 8100fl(config-interface-management)#no shutdown
From Configuration mode, enter the following commands to enable telnet
on the switch:
Switch 8100fl(config)#ip telnet
Switch 8100fl(config-telnet)#no shutdown
Enable a terminal line to the switch by entering:
Switch 8100fl(config)#line vty 0
where 0 represents the vty terminal line connection.
Getting Started With Switch Configuration
Setting Basic System Information
3-3