Verifying The Installation - HP ProCurve 8100fl Series Installation And Getting Started Manual

7. Verifying the Installation

After you have installed all the appropriate components for your switch
(power supplies, fan trays, and the various modules required for your
installation), replace the power and slot covers over any empty power bays
and module slots. Then power on the switch to verify that it is working
properly by following the procedure described on
C a u t i o n
For proper switch cooling and to reduce any electronic emissions, install the
appropriate slot covers over any unused power bays and module slots.
Failure to use the correct slot cover may result in improper switch cooling.
Make sure that you use the correct type of cover for each empty slot. Each
cover is labeled as follows to indicate the type of slot for which it is designed
(part numbers shown in parentheses):
■
■
■
■
■
The following illustration shows a fully loaded Switch 8108fl chassis:
FM Cover for Switch 8008fl fabric module slots (5069-0122)
FM Cover for Switch 8016fl fabric module slots (5069-7937)
MM Cover for management module slots (5069-0123)
IM Cover for interface module slots (5069-0124)
EM Cover for Switch 8116fl expansion module slots (5069-0125)
Installing the ProCurve Switch 8100fl
Installation Procedures
page 2-30.
2-29