Replacing Power Supplies - HP ProCurve 8100fl Series Installation And Getting Started Manual

Replacing Hardware

Replacing Power Supplies

Replacing Power Supplies
If your ProCurve 8100fl Switch is configured with redundant power supplies,
you will not suffer any loss of traffic or performance if a power supply fails.
Simply replace the failed component as soon as possible. The Power Status
LED on the chassis and on the power supply unit itself will indicate which
power supply has failed.
N o t e
The Switch 8116fl chassis requires at least two active power supplies
operating to function correctly.
To remove an AC power supply:
1. Ensure that the AC power supply is not plugged into an AC power source.
2. Insert a flat blade screwdriver (or similar lever device) into the indent
3.
4. Pull on the handle to slide the power supply from the chassis.
To install a new or replacement power supply, follow the procedure described
on
4-2
located on the bottom edge in the center of the handle.
Gently turn the screwdriver with the handle downward and lower the
power supply handle to its fully extended position.
page 2-24.