Danfoss TripleLynx Installation Manual page 23

4. Start-up and Check of Settings
4
Illustration 4.7: Master Mode
22
To enable Master mode go to the
details menu [Setup → Inverter details →
Master mode] and set Master mode to
bled. Ensure that no other master inverters
are present in the network prior to carrying
out this action.
When Master mode is enabled, it is possible
to initiate a network scan [Setup → Inverter
details → Master mode → Network]. This will
show all inverters connected to the master
inverter.
L00410309-07_02
Inverter
Ena-