Discontinuing A Measurement; Memory - Storage And Recall Of The Measurements; Error Messages/Malfunctions - Microlife BP 3BE0-4 Instruction Manual

d) When the measurement has been concluded, a long peep tone
sounds. The measured systolic and diastolic blood pressure values as
well as the pulse frequency are now displayed.
Example (Fig.): Systole 118, Diastole 73, Pulse 75
The measurement results are displayed, until you switch the device off. If no button is pressed
for 5 minutes, the device switches automatically off, to save the batteries.

5.5. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for any reason
(e.g. the patient feels unwell), the O/I button can be pressed at any time.
The device then immediately lowers the cuff-pressure automatically.
5.6. Memory – storage and recall of the measurements
The blood pressure monitor automatically stores each of the last
30 measurement values. By pressing the M-button, the last
measurement (MR1) as well as the further last 29 measurements
(MR2, MR3, ..., MR30) can be displayed one after the other.
TIME
DATE
MR
MR
(MR1: Values of the last measurement) (MR2-MR30: Values of the measurement before MR1)

6. Error messages/malfunctions

If an error occurs during a measurement, the
measurement is discontinued and a corresponding error
code is displayed (Example: Error No. 2).
8
TIME
DATE
MR
MR