Faceplate Installation - Regency Fireplace Products Horizon HZ42E-NG Owners & Installation Manual

1) Hook the fl ange on the back of the faceplate over the top edge of
the glass door - as shown below.
Faceplate
2) The height at which the faceplate sits may be adjusted to maintain
an even space between the upper faceplate and
lower faceplate panel.
The upper faceplate can be raised up once the
lower faceplate panel is in position - by adjusting the 2 screws
at the back of the upper faceplate - see below
(requires an extended phillips head screw driver)
.
HZ42E Regency Horizon™ Gas Fireplace

FACEPLATE INSTALLATION

The bottom panel of the faceplate installs on the unit with 2 slides.
These slides are located in the bottom of the unit - already installed
within the outer slide. The inner slides need to be removed to install
them on the brackets.
3) Pull out inner slide from the outer slide.
4) Push done on the black lever on the outside of the inner slide - this will
release the inner slide. Pull inner slide completely out - from outer slide.
Glass Door
5) Lay out the brackets for the lower faceplate to identify the left and
right brackets.
6) Install the brackets onto the lower faceplate.
Note: Installation location of the left and right brackets is the same for
Left Bracket
both the HZ42 and HZ42ST.
Top of lower
faceplate
Right bracket shown in position on lower faceplate.
INSTALLATION
Right Bracket
47