Gt Remote Installation - Regency Fireplace Products Horizon HZ42E-NG Owners & Installation Manual

DFBC = digital fi replace burner control
1) Remove the faceplate and glass door to access to DFBC &
battery pack tray.
2) Lift DFBC and battery pack up and out.
HZ42E
3) Disconnect connector from battery holder and remove from tray – (battery
holder is attached by Velcro to tray).
HZ42E
4) Remove the 4 AA batteries if installed, reconnect the connector to the
battery pack and put back onto Velcro strip
HZ42E Regency Horizon™ Gas Fireplace

GT REMOTE INSTALLATION

5) Locate the DFC wire from the receiver wire harness and connect to the
HZ42STE
Note: DO NOT USE 4 AA batteries in the battery pack on the tray - the
HZ42STE
DC supply wire from the DFBC.
DFBC is now powered by the receiver batteries in the wall.
INSTALLATION
37