Autonet; Btconfig - Ricoh Printer Quick Installation Manual

Monitoring and Configuring the Printer
• Timeout value becomes ineffective.

autonet

Use the "autonet" command to configure AutoNet parameters.
❖ View settings
The following command displays the current AutoNet settings:
msh> autonet
❖ Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
• {on} means "active" and {off} means "inactive".
❖ Current interface priority configuration display
msh> autonet priority
❖ Interface priority configuration
msh> autonet priority "interface_name"
• You can give interface's AutoNet parameter priority.
• Priority settings are available when multiple interfaces are installed.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface name
ether
ip1394
wlan
❒ If an interface is not selected, the current interface connection settings remain
in effect.
For details about AutoNet, refer to autonet parameters.

btconfig

Use the "btconfig" command to make Bluetooth settings.
❖ View settings
Bluetooth settings are displayed.
msh> btconfig
Interface configured
Ethernet interface
IEEE 1394 interface
IEEE 802.11b interface
183