Replacing The Memory Module(S) - Dell Studio 1735 Service Manual

1 memory module connector
3 memory module
Replacing the Memory Module(s)
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
1. Align the notch in the module edge connector with the tab in the connector slot.
2. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not feel the click, remove the
module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may not boot.
1 tab
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.
3. Replace the base cover (see
4. Slide the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
5. Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
To confirm the amount of memory installed in the computer, click Start
Back to Contents Page
2 securing clip (2)
2 notch
Replacing the Base Cover).
® Help and Support® Dell System Information.