Communication Cards; Subscriber Identity Module - Dell Studio 1735 Service Manual

Back to Contents Page
Communication Cards
Dell™ Studio 1735/1737 Service Manual
Subscriber Identity Module
Wireless Mini-Cards
Subscriber Identity Module
Subscriber Identity Modules (SIM) identify users uniquely through an International Mobile Subscriber Identity.
Installing the SIM
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: Only GSM (HSDPA) type cards need a SIM. EVDO cards do not use a SIM.
1. Follow the procedures in Before You
2. In the battery bay, slide the SIM into the compartment.
1 SIM eject bar
3 SIM
Removing the SIM
1. Press the SIM eject bar to release the SIM.
2. When it is partially ejected, remove the SIM from the battery bay.
Wireless Mini-Cards
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is
not covered by your warranty.
NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports three Mini-Card slots:
two Full Mini-Card slots – for WWAN, WPAN, UWB, Bluetooth
l
Begin.
2 battery bay