Replacing The System Board - Dell Studio 1735 Service Manual

that are located next to the screws on the system board.
1 system board 2 screw (5)
3 charger board connector 4 charger board
5 audio cable connector 6 microphone cable connector
7 fan cable connector
13. Disconnect the microphone cable connector, fan cable connector, and audio cable connector.
14. Pull the system board to detach it from the connector on the charger board.
15. Lift the system board at an angle toward the side of the computer and out of the computer base.
Replacing the System Board
1. Replace the system board in the computer base.
2. Connect the system board to the connector on the charger board.
3. Connect the microphone cable connector, fan cable connector, and audio cable connector.
4. Replace the five screws (in the reverse order of removal) that secure the system board to the computer base.
5. Replace the optical drive (see
6. Replace the palm rest (see
7. Replace the display assembly (see
8. Replace the keyboard (see
9. Replace the center control cover (see
10. Replace the processor heat sink and processor (see
11. Replace the hard drive (see
12. Reinstall the memory modules and Mini-Cards, if any.
13. Reinstall any removed cards in the ExpressCard and 8-in-1 card slots.
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
14. Turn on the computer.
NOTE: After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.
Replacing the Optical Drive).
Replacing the Palm Rest).
Replacing the Display Assembly).
Replacing the Keyboard).
Replacing the Center Control
Replacing the Processor Heat Sink
Replacing the Hard Drive).
Cover).
and Installing the Processor).