Assembly - Progear Fitness 1113 Owner's Manual

2
4
61
1
1. Front and Rear Stabilizers Installation
Remove the Ø10x110 Safety Pin (38) from the bike. Pull the Rear and Front Frames
(1, 2) apart from each other. Align pin holes for inserting the Ø10x110 Safety Pin (38)
then insert the removed Ø10x110 Safety Pin (38) into the holes on the Rear and Front
Frames (1, 2) to lock the frames in place.
Remove the Ø8x110 Safety Pin (22) from the bike. Pull the Computer Frame (4)
forward and align pin holes for inserting the Ø8x110 Safety Pin (22) then insert the
removed Ø8x110 Safety Pin (22) into the holes on the Computer Frame (4) and Front
Frame (2) to lock the Computer Frame (4) in place.
Remove the Ø8x65 Safety Pin (92) from the bike. Pull the Retractable Support Rod (61)
up and align pin holes for inserting the Ø8x65 Safety Pin (92) then insert the removed
Ø8x65 Safety Pin (92) into the holes on the Front Frame (2) and Retractable Support
Rod (61) to lock the Retractable Support Rod (61) in place.
Position the Front Stabilizer (19) in front of the Front Frame (2) and align bolt holes.
Attach the Front Stabilizer (19) onto the front curve of the Front Frame (2) with two
Ø8xØ25x1.5 Big Curve Washers (28) and two M8 Hexagon Cap Nuts (29). Tighten cap
nuts with the Double Open End Wrench provided.
Position the Rear Stabilizer (3) behind the Rear Frame (1) and align bolt holes.
Attach the Rear Stabilizer (3) onto the rear curve of the Rear Frame (1) with two
Ø8xØ25x1.5 Big Curve Washers (28) and two M8 Hexagon Cap Nuts (29). Tighten cap
nuts with the Double Open End Wrench provided.

ASSEMBLY

22
38
29
28
92
3
2
1
Tool:
29
28
Double Open End Wrench 13#, 15#
9
29
28
19