Advertisement
C. OPERATING INSTRUCTIONS
Note: All locks are shipped with the following combination:
#2 and #4 pushed at the same time, then #3. For proper security,
the factory set code must be changed at the time of installation.
C-1
Gaining Access By Combination Code
A. To clear any previously depressed code buttons, turn the thumb
turn to the left (counterclockwise) and release (See Figure 3-1).
B. Depress the code buttons in the proper order of your
combination. Release buttons after depressing.
C. Turn the thumb turn clockwise to the stop position. Observe the
latch being retracted to unlock the door (See Figure 3-2). The
lock will lock automatically when the thumb turn is released.
C-2 Gaining Access By Key Override
Insert cylinder key into cylinder on combination lock side of
door. Turn the key in clockwise direction (approximately 90°)
(See Figure 3-3). The latch should retract. Turn the key back to
key pull position and remove.
C-3 Locking Out Combination Code Access
A. Insert cylinder key into cylinder on combination lock side
of the door. Turn key in a counterclockwise direction to the
stop position (See Figure 3-4). Return the key to the pull
position and remove. The thumb turn should not turn while
the lock is in this mode.
B. To allow access again through a combination code, insert
key, turn clockwise approximately 45°. Return the key to
the pull position and remove (See Figure 3-5).
6
Figure 3-1
Figure 3-2
Figure 3-3
Figure 3-4
Figure 3-5
Hide quick links:
Advertisement
