Setting Bitpacked Options With The Terminal - Liebert Static Transfer Switch 2 Installation, Operation & Maintenance Manual

Table 12 Group Settings and Values
Group
Group 3:
User
Settings
Group 4:
Event Mask
Settings

12.1.3 Setting Bitpacked Options with the Terminal

Five sets of options and features settings are available through the terminal to control the system
operation.
Under System Settings for the SPT command, these items denote which options are INSTALLED:
• 6 — Options_1
• 14 — Comms Options 1
• 15 — Comms Options 2
Under User Settings, for the SPT command, these items denote which features are ENABLED:
• 17 — Critical Option Enabling
• 18 — Non-Critical Option Enabling
74 Communication Interfaces
Item: Description
1 SRC1 Fast Undervoltage
Setpoint
2 SRC1 Slow Undervoltage
Setpoint
3 SRC1 Slow Undervoltage
Detect Delay
4 SRC1 Overvoltage
Setpoint
5 SRC1 Overvoltage Detect
Delay
6 SRC1 I peak Transfer
Setpoint
7 SRC2 Fast Undervoltage
Setpoint
8 SRC2 Slow Undervoltage
Setpoint
9 SRC2 Slow Undervoltage
Detect Delay
10 SRC2 Overvoltage
Setpoint
11 SRC2 Overvoltage Detect
Delay
12 SRC2 I peak Transfer
Setpoint
13 Max. Transfer Phase
Angle
14 Output Frequency
Deviation
15 ReTransfer Delay Time
16 Horn Volume
17 Critical Option Enabling
18 Non-Critical Option
Enabling
1 to Event Mask settings for
63 faults
64 to Event Mask settings for
143 alarms
Value Type
Integer In % of nominal below nominal
Integer In % of nominal below nominal
Integer In number of lines cycles
Integer In % of nominal above nominal
Integer In 1/4 lines cycles
Integer x 10
Integer In % of nominal below nominal
Integer In % of nominal below nominal
Integer In number of lines cycles
Integer In % of nominal above nominal
Integer In 1/4 lines cycles
Integer x 10
Integer In degrees
Integer Freq. in Hz x 10
Integer In seconds
Integer Range: 1-10
Bitpacked See section 12.1.3.
Bitpacked See section 12.1.3.
Event Mask See section 12.1.4.
Event Mask See section 12.1.4.
Value Notes