4.0
L
OCATING THE
This section provides instructions for leveling the STS2 and anchoring the unit to the floor, should
that be required.
For leveling feet details, see Figure 5 through Figure 10 in section 7.0 - Installation
Drawings on page 23.
4.1
Leveling and Anchoring the Unit to the Floor
The STS2 can be anchored to the concrete floor to ensure stability for the unit in the event of seis-
mic activity.
The seismic brackets are an option for the STS2 and are shipped separately from the unit when
ordered.
See Figure 11 on page 29 through Figure 13 on page 31 for instructions and details for installing
seismic anchoring.
4.2
Leveling of the Static Switch Without Anchoring
The Static Transfer Switch is furnished with casters and leveling feet. After final positioning of the
unit, adjust the leveling feet located in each corner of the frame base to level and stabilize the unit.
12
Locating the STS2
STS2