Verify That All Hardware Is Present - IBM eserver pSeries 690 Installation Manual

Physical Memory
Secondary I/O
Book
Secondary I/O
Book

Verify that All Hardware is Present

Verify that all hardware is present by doing the following at the command line:
v Run lsslot -cpci to verify the adapters are plugged into the physical slot they are
plugged in. Make note of the adapter types and positions the adapters are plugged
in.
v Run lsdev -Cc adapter to verify that all the adapters are in the available state. If any
adapters are in defined state, contact your next level of support.
v Run lspv and count the number of hdisks (hard disks) that appear in the system.
Verify that the number equals the number of hard disks physically in the system.
Make note of the hard disks and which one(s) contain rootvg (root volume group).
v Run lsdev -Cc disk to verify that all the hard disks are in the available state. If any
of the hard disks are in the defined state, contact your next level of support.
v Run lsattr -El mem0 to verify the total amount of memory recognized by the system.
If the total is not the correct amount, contact your next level of support.
v Run bindprocessor -q to verify how many processors are available. If the correct
number or processors are not available, contact your next level of support.
Location available
Card
v U1.18-P1-H3 - I/O Slot 2
- Drawer 5
v
Drawer 6
v U1.18-P1-H4 - I/O Slot 3
- Drawer 7
v
Drawer 8
Other Information
v
Outside RIO Connector A0 and A1
v
Outside RIO Connector B0 and B1
v
Outside RIO Connector C0 and C1
v
Outside RIO Connector D0 and D1
Appendix F. System Records
73