Mounting Internal Rack Components - IBM eserver pSeries 690 Installation Manual

Hide thumbs Also See for eserver pSeries 690:
Table of Contents

Advertisement

Item 9 in illustration on
page 46.
Item 10 in illustration on
page 46.
Item
Illustration on page 56.
Item 3 in illustration on
page 46.
Item 5 in illustration on
page 46.
Item 8 in illustration on
page 46.
Item 6 in illustration on
page 46.
Item 2 in illustration on
page 46.
Item 7 in illustration 46.
Item 1 in illustration on
page 46.
Item 9 in illustration on
page 46.
Item 10 in illustration on
page 46.

Mounting Internal Rack Components

To mount the internal rack components, do the following:
Attention:
1. Using four M-8 (20 mm) screws (item 1 in illustration on page 46), install the top
shipping bar (item 2 in illustration on page 46) at EIA unit location 32.
2. Using four M-8 screws (item 1 in illustration on page 46), install the bottom
shipping bar (item 3 in illustration on page 46) at EIA unit location 18.
3. Repeat steps 1and 2 to install shipping bars in the rear of the rack.
4. Attach the front top hinge (item 5 in illustration on page 46) on the vertical rail
(located approximately at EIA unit 29-30 on the vertical rail) with two 25 mm
screws (item 9 in illustration on page 46) and two washers (item 10 in illustration
on page 46).
5. Attach the front bottom hinge (item 5 in illustration on page 46) on the vertical rail
(located approximately on EIA unit 6-7 on the vertical rail) with two 25 mm screws
(item 9 in illustration on page 46) and two washers (item 10 in illustration on page
46).
1621546
1622307
11P4758 Frame Tie-down Kit (Long-Raised Floor) (RPQ 8A1186)
Part Number
44P0674
11P3527
11P3529
11P3530
11P3531
11P3532
76X4687
1624804
1621546
1622307
This procedure is performed by the service representative.
8
Screw (hex, 25mm, long, hinge)
8
Washer (M-8, hinge)
Qty
Description
4
Turnbuckle Assembly (long)
2
Shipping bar (lower)
4
Hinge plate
2
Latch plate
2
EQ support
2
Shipping bar (upper)
2
Latch bolt
20
Screw (hex flange, 20mm, long)
8
Screw (hex, 25mm, long, hinge)
8
Washer (M-8, hinge)
Appendix D. Securing the Rack
45

Advertisement

Table of Contents
loading

Table of Contents