Installing The Rack Top Frame - IBM eserver pSeries 690 Installation Manual

Proceed to "Installing the Rack Top Frame".

Installing the Rack Top Frame

This section contains information on installing the rack top frame.
1. If you have not done so, use the Jack screws to stabilize and lift the rack off the
floor, as follows:
a. Loosen the jam nut on each leveling foot by turning the nut counterclockwise.
b. Rotate each leveling foot downward until it contacts the surface on which the
c. Adjust the leveling feet downward as needed until the rack is level. When the
1
2. Position the rack top frame on top of the rack by orienting the two front labels on
the rack top frame assembly and the frame. As you are facing the frame, this label
is on the right front of the frame.
Note: Two people are required to lift and position the top frame assembly. To assist
rack is placed.
rack is level, tighten the jam nuts against the base by turning the nut clockwise.
2 3
1 Jam Nut
2 Rack Base
with the installation, a stepladder and ladder are provided with the reduced
Appendix J. Removing and Installing the Rack Top Frame
3 Rack Base
111