Verify That All Hardware Is Present - IBM eserver pSeries 690 Installation Manual

Physical Memory
Secondary I/O
Book
Secondary I/O
Book

Verify that All Hardware is Present

|
| Verify that all hardware is present by doing the following:
v Run lsslot -cpci to verify the adapters are plugged into the physical slot they are
|
|
plugged in. Make note of the adapter types and positions the adapters are plugged
| in.
v Run lsdev -Cc adapter to verify that all the adapters are in the available state. If any
|
|
adapters are in defined state, contact your next level of support.
v Run lspv and count the number of hdisks (hard disks) that appear in the system.
|
|
Verify that the number equals the number of hard disks physically in the system.
|
Make note of the hard disks and which one(s) contain rootvg.
v Run lsdev -Cc disk to verify that all the hard disks are in the available state. If any
|
|
of the hard disks are in the defined state, contact your next level of support.
v Run lsattr -El mem0 to verify the total amount of memory recognized by the system.
|
|
If the total is not the correct amount,contact your next level of support.
v Run bindprocessor -q to verify how many processors are available. If the correct
|
|
number or processors are not available, contact your next level of support.
Location available
Card
v U1.18-P1-H3 - I/O Slot 2
- Drawer 5
v
Drawer 6
v U1.18-P1-H4 - I/O Slot 3
- Drawer 7
v
Drawer 8
Other Description Information
v
Outside RIO Connector A0 and A1
v
Outside RIO Connector B0 and B1
v
Outside RIO Connector C0 and C1
v
Outside RIO Connector D0 and D1
Appendix F. System Records
81