Handling Static-Sensitive Devices; Returning A Device Or Component; Removing The Left-Side Cover And Bezel - IBM System x3500 Service Manual

Type 7977
Hide thumbs Also See for System x3500:
Table of Contents

Advertisement

Handling static-sensitive devices

Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when you handle devices during cold weather. Heating

Returning a device or component

If you are instructed to return a device or component, follow the packaging
instructions provided with the replacement part. Use any packaging materials for
shipping that are supplied to you.

Removing the left-side cover and bezel

Cover release latch
To remove the left-side cover and bezel complete the following steps:
1. Read the safety information that begins on page vii and "Handling
Static electricity can damage the server and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available. Always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
metal part on the outside of the server for at least 2 seconds. This drains static
electricity from the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
reduces indoor humidity and increases static electricity.
Lock
Left-side cover
static-sensitive devices."
Chapter 4. Removing and replacing server components
57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents