Installation Instructions - SPT WA-6022S User Manual

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT-
instructions for local inspector's use.
IMPORTANT-
governing codes and ordinances.
Note to Installer
instructions with the Consumer.
Note to Consumer
instructions for futrue reference.
-
Skill level
Installation of this appliance
requires basic mechanical skills.
Completion time
We recommend that two people install
this product.
Proper installation is the responsibility
of the installer.
Product failure due to improper installation
is not covered under the Warranty.
You MUST use all supplied parts and use
proper installation procedures as described
in these instructions when installing this air
conditioner.
WINDOW REQUIREMENTS
Your air conditioner is designed to install in
standard double hung windows with opening
widths of 23 to 36 inches(584mm to 914mm).
Lower sash must have sufficient vertical
opening for installation (Table 1)
OFFSET
EXTERIOR
WALL
INNER
WINDOW SILL
INTERIOR
WALL
Model
WA-6022S/WA-8022S
Min. Vertical
14" (356mm)
Opening
Save these
Observe all
-
Be sure to leave these
-
Keep these
-
Approximately 1 hour.
H
WA-1022S/WA-1222S
15.5" (394mm)
Table 1
CAUTION
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
Do not change the plug on the power cord
of the air conditioner.
Aluminum house wiring may present special
problems- consult a qualified electircian.
When handling the unit, be careful to avoid cuts
from sharp metal edges and aluminum fins located
on the front and rear coils.
TOOLS YOU WILL NEED
TOOLS YOU MAY USE
NOTE:
Save carton and these installation instructions
for future reference. The carton is the best way
to store unit during winter or when not in use.
4
Phillips
screwdriver
Leveler
Slotted screwdriver
Pencil
Ruler or tape measure
Scissors or knife