Aftercooler Core - Inspect; Alternator - Inspect; Alternator And Fan Belts - Replace; Aftercooler Core - Clean/Test - Perkins 854E-E34TA Operation And Maintenance Manual

84
Maintenance Recommendations

Aftercooler Core - Clean/Test

Aftercooler Core - Clean/Test
(Air-To-Air Aftercooler)
The air-to-air aftercooler is OEM installed in many
applications. Please refer to the OEM specifications
for information that is related to the aftercooler.

Aftercooler Core - Inspect

Note: Adjust the frequency of cleaning according to
the effects of the operating environment.
Inspect the aftercooler for these items: damaged fins,
corrosion, dirt, grease, insects, leaves, oil and other
debris. Clean the aftercooler, if necessary.
For air-to-air aftercoolers, use the same methods that
are used for cleaning radiators.
Personal injury can result from air pressure.
Personal injury can result without following prop-
er procedure. When using pressure air, wear a
protective face shield and protective clothing.
Maximum air pressure at the nozzle must be less
than 205 kPa (30 psi) for cleaning purposes.
After cleaning, start the engine and accelerate the
engine to high idle rpm. This will help in the removal
of debris and drying of the core. Stop the engine. Use
a light bulb behind the core in order to inspect the
core for cleanliness. Repeat the cleaning, if
necessary.
Inspect the fins for damage. Bent fins may be opened
with a "comb".
Note: If parts of the aftercooler system are repaired
or replaced, a leak test is highly recommended.
Inspect these items for good condition: Welds,
mounting brackets, air lines, connections, clamps and
seals. Make repairs, if necessary.
i01807350

Alternator - Inspect

Perkins recommends a scheduled inspection of the
alternator. Inspect the alternator for loose
connections and correct battery charging. Check the
ammeter (if equipped) during engine operation in
order to ensure correct battery performance and/or
correct performance of the electrical system. Make
repairs, as required.
i02322295
Check the alternator and the battery charger for
correct operation. If the batteries are correctly
charged, the ammeter reading should be very near
zero. All batteries should be kept charged. The
batteries should be kept warm because temperature
affects the cranking power. If the battery is too cold,
the battery will not crank the engine. When the engine
is not run for long periods of time or if the engine is
run for short periods, the batteries may not fully
charge. A battery with a low charge will freeze more
easily than a battery with a full charge.
Alternator and Fan Belts -
Replace
1. Remove the guard that covers the alternator. Refer
to the Original Equipment Manufacture (OEM) for
the correct procedure.
SEBU8726
i02322311
i04407613