Punching File Holes In Copies (Punch); To Punch File Holes In Copies - Konica Minolta bizhub pro 920 Copier Manual

Finishing / Paper Fold
12.8

Punching File Holes in Copies (Punch)

The Finisher FS-509/FS-516/FS-604 with Z folding unit ZU-602 or Punch kit
PK-505 installed can punch file holes in output copies.
This mode is available in combination with Z-Fold or Staple mode.
Reminder
Do not punch special paper type such as OHP transparencies, labels,
tracing paper, etc. Otherwise, machine trouble may occur.
Be sure that the side guide plates of the paper tray are securely aligned
to the paper; otherwise the copies may not be punched in position.

To punch file holes in copies

0 Number of holes: 2 or 3
0 Hole diameter: ZU-602; 0.315" ± 0.020" (8 ± 0.5 mm)
PK-505; 0.315" ± 0.006" (8 ± 0.15 mm)
0 Hole pitch: 2 holes; 2.756" ± 0.020" (70 ± 0.5 mm)
3 holes; 4.252" ± 0.020" (108 ± 0.5 mm)
0 Paper size: 2 holes; 11"×17", 8.5"×14", 8.5"×11", 8.5"×11"R, 5.5"×8.5",
5.5"×8.5"R, A3, B4, A4, A4R, B5, B5R, A5, A5R
3 holes; 11"×17", 8.5"×11", A3, B4, A4, B5
0 Paper weight: 16 to 24 lb (20 lb recommended), Thick paper (25 to 45 lb),
Thin paper (13 to 15 lb)
0 If the ATS (Automatic Tray Switching) functions while the machine uses
the Punch mode, the punch holes may be slightly off the appropriate po-
sitions.
0 Special size paper (sizes in Original Size Detection, Custom, Wide Size or
Tab Paper) cannot be punched.
bizhub PRO 920
2.756"
(70 mm)
4.252"
(108 mm)
12
12-23