Maxtor OneTouch User Manual page 13

(Please do not eject the Install CD.)
If you don't see the Please Reboot message, move to the
next step.
If you have chosen not to not install Retrospect, move to the
Connecting the Drive section on the next page.
12. The Retrospect 6.0 Installshield Wizard will appear.
click Next.
The License Agreement screen should now appear.
13. After reading the agreement, select "I accept. ." and
click Next.
The Customer Information screen will appear.
14. Fill in your information and click Next.
The Setup Type screen will appear.
15. You can choose the Complete Installation (recommended) to
install all of the Retrospect Software or Custom Installation to
choose individual components and specify an install location.
Note: If you do not install the Retrospect program, you will not
be able to use it with the OneTouch backup feature described
later in this guide.
Make your choice and click Next.
The Ready to Install screen appears. If you're ready to install
the Retrospect software, click Install to begin installing the
software on your computer.
16. After the software is installed on your system, a message is
displayed "InstallShield Wizard completed" signifying that
your installation was successful.
17. Click the Finish button.
18. Please remove the Maxtor Install CD from your computer.
19. Proceed to the next section: Connecting the Drive.
Windows 2000 and XP:
Connecting the Drive
The Maxtor OneTouch Drive connects to your computer using
either a Firewire or USB interface. Make sure you know which
interface is available on your drive and on your computer.
Please Install the software BEFORE you connect the drive.
Connecting the Power
1. Plug the round female connector from the power adapter into
the drive's power connector.
2. Plug the two-pin female connector on the power cord
into the power adapter.
Figure 3. Connecting the Power
English
Installing Your Drive 9
2